Even more often in inhabited and public premises laminate packing on a floor is applied. Packing of the given floor covering is easy and won't occupy a lot of time, therefore to make it it is possible and is independent. After purchase the laminate should lie in not less than two days at temperature of more than 18 degrees and humidity of less than 70 % that it has adapted premises in which it will stack. While the laminate won't lie in 2 days, he can't be unpacked.
To lay a laminate the hands – to you the hammer, an electrofret saw, a pencil, a ruler, бабышка – the wooden whetstone applied for подбивания of a laminate, a clamp for packing of last panels be required. Packing of a laminate don't make in damp premises. The laminate doesn't need to be put on the basis with heating as because of temperature drops cracks between panels can be formed.
Laminate panels can be laid on an old covering – linoleum, a parquet or another if it meets the requirements on flatness and humidity. It is not necessary to put a laminate on a carpet because of possible «the static category». At a floating way of packing of a laminate on a floor, it can't be attached to the basis in any way.
The surface is necessary for leveling, if there are differences more than 3 mm on 1 m. of the item, then to clear of a dust. Laminate panels have perpendicularly to a light source to hide seams between panels. If the laminate keeps within on the concrete basis it is necessary to lay at first пароизоляцию from a polyethylene film. And then it is possible to spread a substrate under a laminate. Пароизоляция it is not necessary at laminate packing on a timber floor or linoleum.
In the beginning laminate packings are established the first 2 panels, but not them latch, between them and a wall it is necessary to insert распорные wedges in width from 7 to 15 mm. Further laminate panels can at expansion and narrowing to fill the given backlash. Laminate panels need to be stacked the lock to a wall that it was easier to attach following panels. Then the second row which begins with a panel half is put. Last panel among keeps within with clamp application. When panels will be laid on all surfaces of a floor, on premise perimeter the plinth is established. If the lock of one panel doesn't enter into another then it is necessary to file a little the lock and to fix panels among themselves special glue for a laminate.
|
