Packing of a floor tile |
|
Floor tile stack after it is already laid on walls. Often a tile stack on a floor in parallel a wall but that the floor looked more original, it is possible to put a tile and on a diagonal that demands more time and professionalism of a tiler. For packing of a tile it is required to you: tiled glue, a mix cement-sandy, concrete-contact, daggers, wedges, затирка, gear шпатель in the width 15 sm, rubber шпатель for затирки, плиткорез, level and a tile. The expense of tiled glue on 1м2 approximately from 5 to 15 kg. For a tile in the size 30х30 the sm is better to take daggers in the thickness of 2 mm. Before starting to stack a floor tile, it is necessary to prepare the basis. If the old tile easily departs from the basis it is necessary for cleaning completely and if it can't be cleaned in any way it is possible to put the new at once. In a case when the floor basis has the big roughnesses more than 10 mm which can be measured by means of level, rules and rulers it is necessary to level it cement-sandy mix М-100 or М-150 which should seize before tile packing. The equal basis can to be leveled, but it it is necessary обеспылить, having applied a first coat concrete-contact. Packing of a floor tile begins with a distant or most visible corner indoors. Then it will turn out that the cut off tile will be laid about opposite walls. And to finish tile packing it is necessary about an input in a premise as on just laid tile it is impossible to go to full схватывания tiled glue. Very important correctly to lay out the tile first row. To lay the first row it is necessary to create directing which then is necessary for removing, applying next ways. Most easier to pull a cord along a wall. It is more convenient to use laser level as the beam won't prevent in the course of tile packing. At definition of a thickness of a layer of tiled glue for the first tile it is necessary to consider even small differences of a surface of the basis that all tile has indoors appeared on 5 mm above the highest point of the basis. Glue is put on a tile gear шпателей and as though smeared, that all surface of a tile has been covered. If in tile corners won't be gluing, further it can burst. That the tile has strongly become stronger on the basis, it needs to be pressed down a little, correcting for movements across, and then to measure level flatness of position of a tile. At packing of the second tile daggers that the seam has turned out equal are inserted into a seam between tiles. The glue which has got to a seam between tiles, it is necessary to remove at once. Next day after packing of a floor tile on it it is possible to go. At once clean daggers and can start to затирке seams. Затирку plant with water strictly under the instruction on packing. At drawing затирки it is necessary to rub rubber шпателем in a seam at first on a diagonal to a seam and then to clean its rests along a seam. Try, that затирка has completely filled a seam. The rests затирки that it hasn't dried up on a tile, remove at once from a seam by means of a semidamp sponge. |
| |||||||||||||||||||||||||||||||||||||||||||||||||