Packing of linoleum

Before beginning packing of linoleum on a floor, it is necessary to calculate, how many the material is required to you. Measure a premise on width and length and the size of each party increase on 10 see If you are going to lay linoleum on a diagonal at you will be more waste, than at its packing in parallel a wall. Also a waste will be more in round and oblique-angled premises in comparison with rectangular.

If the surface of a floor which should be dry, pure, without stains of fat, without various ledges and roughnesses, is not ready to packing of linoleum it should be prepared.

New linoleum cannot be laid on the old. Also it is necessary to remove a plinth. How much the floor equal can be checked up by means of level, and the hygrometer is useful for measurement of humidity of a floor.

In premises with the raised humidity before укладывать7г linoleum on a floor, it is necessary to make a waterproofing.

After purchase linoleum should not be laid in the first 2 days, wait while linoleum "will get used" to room temperature. Rolls should be stored in vertical position. Then cloths need to be developed and laid on one days face sheet downwards that cloths were smoothed. Then it is possible to start a marking and разрезке linoleum.

For packing of linoleum on a floor optimum temperature more than 18 degrees.

Put on walls of a mark in height of 10 sm to which linoleum will be bent. That drawing on cloths in the course of packing was not displaced, it is necessary on an underside of a cloth and on a floor to give marks, also it is possible to draw on a floor of a line состыковки cloths of linoleum.

Packing of linoleum on a floor begins from a window. The cloth should be bent on half and to fix any cargo, it is necessary to smear the top part of a cloth with glue. The cloth follows поклеить after the lapse of time, specified in the instruction. Along an edge it is necessary to leave not missed the mark strip for joining of panels. It is impossible to suppose hit of air under a cloth. After проклейки the cloth is necessary прокатать the platen. It is not necessary to stack linoleum on a floor closely to a wall.

In three days after a flooring of linoleum it is possible to start to join panels. It is necessary to cut off panels by means of a knife specially intended for packing of linoleum, then to glue edges and to press them to a floor by means of cargo.

In corners the cut off linoleum should be pressed by means of an angular roller directly into a corner.

After drying of edges it is necessary to make welding of panels of linoleum by special glue which fills a seam.

At end of packing of linoleum it is necessary to establish a plinth on perimetre of a premise which should adjoin to linoleum, but, at the same time, not press it strongly to a floor.